Cambria Home Additions & ADU Nationwide

Cambria Home Additions & ADU: The Fort Myers Owner’s Guide

A Cambria home addition or ADU in Fort Myers typically runs $45,000 to $130,000, depending on square footage, foundation requirements, and finish level - and we stock the materials to build it right the first time. Most homeowners call us when they’ve outgrown their floor plan or need a separate living space for family, and they want Cambria quartz surfaces built into the new kitchen or bath from day one. You’re not just adding square footage - you’re adding value to a property in a market where well-built ADUs are pulling strong rental income, and Cambria countertops in those spaces signal quality to tenants and future buyers alike.

Call (844) 638-7249

The most common trigger is a growing family or an aging parent who needs to be close but not under the same roof. Whatever started you looking, you want a contractor who knows Cambria’s slab dimensions, edge profiles, and installation tolerances - not a crew learning on your job. We’ve built home additions and ADUs across Fort Myers, from McGregor Boulevard to Gateway, and we know what it takes to tie new construction into an existing home without it looking like an afterthought.

Which Cambria Models This Applies To

Cambria quartz surfaces are available in over 140 designs across multiple collections, and all of them are compatible with home addition and ADU construction - the variable isn’t the model, it’s the slab size and the edge profile you choose. Cambria manufactures jumbo slabs at roughly 132 inches by 65.5 inches, which matters when we’re designing a kitchen island or a full-height backsplash for your new space. A smaller ADU kitchen might get away with one slab, while a full-scale addition with a large island and perimeter counters typically needs two or three.

The decision point most Fort Myers homeowners miss is whether to standardize Cambria across the existing home and the new addition. If your main kitchen already has Cambria’s Torquay or Brittanicca finish, matching it in the ADU creates visual continuity that buyers will notice during resale. Cambria’s color consistency is tight batch-to-batch, but we always recommend pulling slabs from the same production run when possible - we handle that coordination so the countertops in your addition don’t read a half-shade different from the rest of the house. We’re an independent contractor, not a Cambria affiliate, which means we source directly through authorized distributors and pass the selection control to you.

Signs Your Cambria Home Additions & ADU Is Failing

Cambria quartz itself doesn’t fail - it’s non-porous, stain-resistant, and harder than granite. What fails is the structure around it, or the install quality from a previous contractor who cut corners. Here’s what we see on service calls in Fort Myers:

• Countertop seam separation at the joint. Florida’s humidity swings cause wood cabinet substrates to expand and contract. If the original installer didn’t use a flexible seam adhesive or didn’t shim the cabinets perfectly level, you’ll see a hairline gap open up between two slabs - usually right at the sink run.
• Overhang deflection on island seating. Cambria requires support brackets or corbels for any overhang beyond 12 inches. If your island has a breakfast bar without adequate steel underneath, the stone will feel springy under weight and eventually crack at the weakest point near the support posts.
• Water staining at the backsplash caulk line. This isn’t the quartz failing - it’s the silicone failing. In a Fort Myers kitchen or ADU bath, daily humidity and splash exposure degrade cheap caulk within two years. The fix is a full strip-and-recaulk with a commercial-grade, mildew-resistant silicone rated for quartz.
• Cracking around the sink cutout. Undermount sinks in Cambria need a minimum 3-inch radius at the corners. A tight 90-degree cut concentrates stress, and if the sink clips loosen over time, the slab cracks right at the inside corner. We’ve replaced enough botched sink cutouts in Fort Myers to know this is almost always an install error, not a material defect.
• Uneven slab height across adjoining pieces. Tolerances for Cambria are tight - less than 1/16-inch variation at the seam. If you can feel a lip with your fingernail where two counters meet, the original installer didn’t spend the time to dry-fit and level the substrate, and you’re going to keep feeling it until someone re-sets the stone.

Replacement Cost & What’s Included

For a Cambria-clad home addition or ADU in Fort Myers, you’re looking at $45,000 on the compact side - think a 400-square-foot studio ADU with a small kitchenette and bath - up to $130,000 for a multi-room addition with a full kitchen, bath, and Cambria surfaces throughout. The Cambria portion of that budget runs $2,000 to $6,500 for countertop fabrication and installation, depending on the design you choose and the linear footage. What drives the full job cost is foundation type (slab-on-grade vs. raised), roof tie-in complexity, and whether we’re running new HVAC and plumbing lines from the main house.

Every estimate we write includes the Cambria material cost, templating, fabrication, delivery, and professional installation by our in-house team. No subcontractor roulette. The 730-Day Done Right Promise covers the entire addition - structure, surfaces, cabinetry, and finish work. If something isn’t right two years in, we make it right. No charge. No argument. That’s what upfront pricing, no surprises actually looks like in writing.

DIY or Call Us?

You can measure your existing countertops and pick a Cambria slab at a showroom yourself - that’s the fun part, and we encourage it. You cannot install Cambria quartz safely or correctly without a vacuum lift, a calibrated laser level, professional seam-setting tools, and the experience to handle a 600-pound stone that cracks if you tilt it wrong. Don’t do it. We’ve seen a homeowner in Fort Myers lose a half-slab in his driveway trying to unload it from a rented truck - that’s a $1,500 mistake that could have paid for a real installation crew twice over.

The physical risks of moving and setting engineered stone are real. A dropped slab can crush a hand or foot instantly. Seam adhesives require precise mixing and rapid placement. If you’re adding an ADU or full addition, the Cambria part is the final touch - but the structure underneath it has to be dead-level and load-rated. Getting the foundation, framing, and rough-in wrong is a much more expensive headache than a countertop mistake. Call us at (844) 638-7249 for a free estimate. We’ll come to your property in Fort Myers, take measurements, and give you a written quote that covers everything - from the slab to the sink to the studs.

FAQs