Kohler Bathroom Remodeling Nationwide

Kohler Bathroom Remodeling: The Fort Myers Owner’s Guide

We stock and install Kohler-compatible bathroom fixtures and parts across Fort Myers, and a full bathroom remodel using Kohler products typically runs between $9,000 and $28,000 installed. Most owners call us after discovering a failed valve cartridge that leaves the shower dripping nonstop, or a toilet flush mechanism that’s cycling water every few minutes, or a finish that’s started to pit from Southwest Florida’s hard, mineral-heavy water. Here’s what you need to know to get the right part matched to your exact model the first time.

Call (844) 638-7249

Which Kohler Models This Applies To

Kohler runs a deeper parts catalog than most homeowners expect. The same Cimarron toilet from 2014 and 2024 use different flush valve seals, and mixing them up means a toilet that runs constantly. In shower valves, the Rite-Temp pressure-balancing cartridge covers the vast majority of fixtures sold in the last 20 years across the Forte, Purist, and Bancroft trim lines, but thermostatic models (usually labeled K-2971-KS or K-TS series) need a different thermostatic cartridge entirely. If you still have the original paperwork, look for the K- number stamped on the underside of the tank lid, or inside the escutcheon plate behind the shower handle. We recommend staying with OEM Kohler parts over aftermarket for any component that touches water flow or seals a gasket. The tolerances on a genuine Kohler ceramic disc cartridge are not something the generic equivalents reliably match, and we’ve pulled too many leaky aftermarket cartridges out of walls in Cape Coral and McGregor to recommend them when the stakes are a water-damaged subfloor. Groundwork Construction Co. of Fort Myers is an independent contractor, not a Kohler affiliate, but we order direct from their distribution network so there’s no question about provenance.

Signs Your Kohler Bathroom Fixture Is Failing

• Shower handle sticks or won’t turn smoothly. Hard water deposits have built up inside the cartridge body. Left alone, you’ll eventually snap the plastic stem off in the wall. We see this in roughly half the shower repairs we do in neighborhoods off Summerlin Road where the water runs harder than average.
• Toilet runs for 15-30 seconds every 10-15 minutes. The flush valve seal has hardened and isn’t seating fully. A new Kohler canister seal stops the cycle and pays for itself on the first water bill.
• Water seeps from the base of the tub spout diverter. The diverter gate inside the spout has corroded. It’s a simple swap on most Kohler slip-fit spouts, but check whether yours is threaded or slip-fit before buying the replacement.
• Chrome finish is blistering or peeling around the drain assembly. This is a material failure, not a cleaning problem. In coastal Fort Myers, salt air accelerates the process on lower-grade finishes, and it usually means the fixture is end-of-life.
• Water temperature swings wildly mid-shower. The pressure-balancing spool inside the cartridge is stuck. A quick fix is flushing the cartridge, but if the spool’s rubber has degraded from chlorine exposure, you need a new cartridge. Kohler’s California-compliant low-flow cartridges have a smaller internal orifice that’s more sensitive to debris, so the symptom shows up faster in Fort Myers homes plumbed before 2005.

Replacement Cost & What’s Included

Installed pricing is where most Fort Myers quotes get fuzzy, so let’s be direct. A single Kohler cartridge replacement runs $225-$425. A full shower valve replacement with new trim runs $1,200-$2,800 depending on whether we’re opening the wall. A complete Kohler bathroom remodel across Fort Myers starts at $9,000 for a smaller footprint and lands around $28,000 for a master bath with a walk-in shower, soaking tub, and custom vanity.

What drives the range inside those numbers: whether we’re matching existing plumbing centers or moving drain locations, whether you’re going with porcelain or cast iron on the tub, and whether the shower enclosure is framed glass or a heavier frameless panel. Every quote includes the parts, labor, and a written line-item scope so you see exactly where the money goes. The number we write is the number you pay. We don’t work off change orders unless you add scope mid-project, and even then it’s approved upfront. Our workmanship is covered under the 730-Day Done Right Promise, which says exactly what it sounds like it says.

DIY or Call Us?

There are things you can safely check, and things you shouldn’t touch. You can test whether a toilet flapper seal is the problem by putting a few drops of food coloring in the tank and watching whether it seeps into the bowl without flushing. You can remove a shower handle and escutcheon plate to check for a visible K- part number. But once you’re dealing with a valve body behind the wall, or a cartridge that won’t budge and needs a puller tool, or anything involving cutting into drywall near supply lines, you want a trained tech on it. Forcing a stuck cartridge and cracking the brass valve body turns a $300 service call into a $2,200 wall-open job. We carry the most common Kohler OEM cartridges and seals on the truck in our Fort Myers service vans, so if we arrive and it’s a straightforward cartridge swap, we’re usually done in under an hour. Call (844) 638-7249 and we’ll get you scheduled. Estimates are free, and a real person picks up.

FAQs