Iron Fence in Pine Manor - Written Price Per Foot, Permit Handled

What a New Iron Fence in Pine Manor Actually Costs and How Long It Takes

An iron fence in Pine Manor typically runs $3,500 to $9,000 for an average residential lot, with most jobs completed in three to five working days once materials are on-site. That number covers removal of any old fencing, new steel posts set in concrete, the iron panels and gate, and Lee County’s required inspections. Call (844) 638-7249 for a line-by-line written estimate built for your specific yard because lot dimensions, gate count, and post conditions in this part of Lee County push that range up or down more than any brochure price can capture.

Call (844) 638-7249

How We Build an Iron Fence in Pine Manor, Start to Finish

Most homeowners want to know what actually happens once they sign the agreement. Here is the real sequence for an iron fence job, not a glossed-over version. We move deliberately because getting post footings right in Pine Manor’s sandy soil and slab-fill lots is the difference between a gate that swings true at five years and one that drags.

Stage 1: Property Marking and Utility Locate (Day 1, 1-2 hours)

We mark the fence line with stakes and spray paint while you walk it with us. This is your chance to adjust the boundary before concrete goes in the ground. Simultaneously, we call in Sunshine 811 for the utility locate, which Florida law requires before any excavation. Lee County inspectors will check for this ticket number on the permit, so we don’t skip it. The locate takes about two business days to clear, and we won’t dig until every utility corridor is marked.

Stage 2: Demolition and Post Hole Excavation (Day 2-3, 4-8 hours depending on old fence)

If there is an existing fence, we pull it and haul the debris same-day. Post holes are augered to 24-inch minimum depth for Pine Manor’s frost-free requirement, though we often go to 30 or 36 inches where the soil is loose fill over shell or sand. Each hole gets a few inches of gravel at the bottom for drainage before the post is set, because standing water around galvanized steel in this humidity accelerates corrosion faster than most people realize. The gate posts get larger diameter holes and heavier steel: those pickets take all the swing load and we overbuild them from the start.

Stage 3: Post Setting and Cure (Day 3-4, 2-3 hours of work, overnight cure)

Steel posts go in, leveled and braced, and we pour high-strength concrete around each one. The concrete needs a minimum overnight cure before any panels are hung. On a shorter run with a single gate, we can sometimes pour in the morning and start hanging panels late the next day. On larger properties with multiple gates and long runs, we stage the pours so one section cures while another gets posts. You’ll make your final gate-swing decision here: inward versus outward, left-hinge versus right. We set the post plates accordingly.

Stage 4: Panel and Gate Installation (Day 4-5, 4-8 hours)

Iron panels are secured to the posts with manufacturer-specified brackets and fasteners, all rust-resistant. Gates get hung, hinges greased, and latch mechanisms dialed in so they close smoothly without rattling. If you chose a powder-coated finish, we touch up any bracket scuffs before we leave. This is also when we walk the full fence line with you and mark anything that needs adjustment on our punch list, which we clear before calling the final inspection.

Stage 5: Lee County Inspection and Close-Out (Day 5+, 30-60 minutes)

A Lee County building inspector checks post depth, gate operation, and compliance with the wind-load and setback requirements listed on your permit. We are on-site for that inspection and handle any correction notes immediately. Once it passes, you have a signed final on file with the county, which matters for property records and insurance documentation. The entire process from permit submission to signed final typically wraps inside two weeks for a standard residential iron fence in Pine Manor.

A note on safety: Iron fence installation involves handling heavy steel panels and setting posts in concrete, which can be dangerous if done without the right equipment and crew coordination. We recommend hiring trained, insured professionals for every stage of this job.

The Options You’ll Choose Between

Iron fence isn’t one product. A handful of choices shape both the price and how the fence holds up five years from now in Pine Manor’s humidity and storm exposure. Here are the ones that matter most:

• Steel gauge and profile: Residential iron fencing typically comes in 16-gauge or 14-gauge steel, with 14-gauge being thicker and stiffer, better for taller panels and high-wind exposure. Pressed spear-top pickets are the classic look. Flat-top or arched profiles cost about the same but change the finished aesthetic substantially. Thicker gauge costs more up front and resists denting from flying debris far better during hurricane season.
• Finish type: Powder coating is the standard now, baked on at the factory for a uniform color that resists chalking and rust better than wet paint. Galvanized undercoating beneath the powder coat is the upgrade that matters most in coastal-adjacent ZIP codes: it stops rust from starting at scratched spots. Expect to pay a premium for galvanized-under-powder, and expect it to be worth it within five years on a Pine Manor property.
• Gate configuration: A single walk gate adds cost for the gate frame, hinges, latch, and the heavier posts. A double drive gate for vehicle access can double the gate cost. The number of gates in your layout is the single biggest variable inside that $3,500 to $9,000 range. Tell us during the estimate where you need access, and we’ll price it line by line.
• Height and spacing: Most Pine Manor residential iron fences are 4 or 5 feet tall. Six feet is available but adds material cost and may trigger a different Lee County setback review. Picket spacing is typically 3.5 to 4 inches, close enough that most pets and kids won’t slip through but open enough to maintain sightlines and wind permeability, which helps the fence survive high gusts instead of acting like a sail.
• Brand partnerships: We source iron fencing through trusted manufacturers like ActiveYards because their factory tolerances and finish consistency hold up across the dozens of panels we install each month. We are not locked into one catalog. If your HOA or personal preference specifies a particular profile, we can match it from multiple supply channels.

What Iron Fence Costs in Pine Manor, FL

A new iron fence in Pine Manor lands between $3,500 and $9,000 on a typical single-family lot. That is a built-and-inspected price covering removal of the old fence, all materials, concrete footings, gate hardware, Lee County permit fees, and the final inspection. Jobs under $4,500 are usually shorter runs with one standard walk gate, good access, and no surprises underground. Jobs above $7,500 have longer linear footage, a double drive gate, higher-end finish specifications, or tricky post-hole conditions that add labor hours.

What pushes the number toward the low or high end:

• Linear footage: The single biggest driver. More fence costs more, period. We measure to the inch on the estimate and quote accordingly.
• Gate count and type: A single walk gate adds a few hundred dollars. A double drive gate with a heavier frame and hardware can add over a thousand. If you need an electric opener or intercom, that is a separate line item we’ll walk you through.
• Old fence removal: Pulling an existing chain-link or wood fence and hauling it away adds labor and disposal cost. If the old posts are set in deep concrete, that adds demolition time. We’ll tell you what’s there before we start.
• Soil and access conditions: Pine Manor lots with loose fill, buried construction debris, or tight side-yard access increase excavation time. We price for what we can see and tell you as soon as we hit something unexpected.
• Finish upgrades: Galvanized undercoating beneath the powder coat and taller panel heights both move the materials line up. We quote both the standard and the upgrade with the real price difference so you can decide with numbers in hand.

Every Groundwork Construction Co. estimate is a written, line-item document. No range that widens later, no surprises buried in fine print. The number you approve is the number you pay. We also offer 0% financing for 18 months and $1,000 off projects over $10,000. If your iron fence is part of a larger outdoor project, for example paired with new Patios, Walkways & Pool Decks in Pine Manor, those breaks can bring the total cost down meaningfully.

How Pine Manor Specifically Changes an Iron Fence Job

Pine Manor sits in unincorporated Lee County, which means every iron fence project goes through Lee County permitting, not a municipal office. That is the single most important local reality. Since Hurricane Ian made direct landfall on Lee County in 2022, the building department has been processing a reconstruction surge, and permit review times depend heavily on how complete the submittal package is the first time it hits the desk. We file permits with wind-load calculations and site plans drawn exactly the way the reviewers expect, and that keeps your project moving while incomplete applications sit in queue.

The housing stock itself matters, too. Many of Pine Manor’s concrete-block homes from the 1960s through 1980s sit on lots where original fence lines were either never installed or were put in with materials that did not survive Ian’s 150-plus-mile-per-hour gusts. We regularly find old chain-link posts snapped at ground level or rusted through where sprinkler runoff pooled for years. The sandy, fast-draining soil in this part of southwest Florida makes for easy excavation most days but demands deeper, wider footings on gate posts because there is less natural lateral resistance than you’d get in clay soil upstate. We adjust the post-hole diameter and depth in real time based on what the auger brings up.

Homeowners in Pine Manor often pair an iron fence with a larger property overhaul. Some are hardening the entire perimeter after storm damage, and others are adding an ADU and need a defined, secure yard. We have done that sequence enough times that we can coordinate the fence schedule with an ADU Design & Permitting in Pine Manor project so the yard is finished and usable the same week the unit gets its certificate of occupancy. If you are planning a full Fence Installation in Pine Manor with multiple materials across a larger property, our Fence Installation crew can fold the iron portion into a single permit package so the whole perimeter gets inspected together.

We work throughout Pine Manor and cover every pocket of this community. The defining local factors are consistent across the entire area: Lee County permitting, post-Ian wind-hardening standards, and the reality that hurricane season runs June through November every single year. A fence built to those conditions will outlast one that was not.

Frequently Asked Questions About Iron Fence in Pine Manor

Get a Written Iron Fence Estimate in Pine Manor

A good iron fence starts with a real number on paper, not a ballpark. Call (844) 638-7249 to schedule a free on-site estimate. Derek Hollenbeck and the team will walk your property, measure the full run, talk through gate placement and finish options, and hand you a complete line-item price before we leave. No pressure, no vague ranges, and a live person answers when you call, day or night.

Written by Derek Hollenbeck, Owner at Groundwork Construction Co., serving Pine Manor and Lee County with straight numbers and work that stays done.